Release 18.9 must be used with a licensed Ross-Tech interface. Windows 95, 98, ME, and NT4 definitely will not work. Windows running in a VM (Parallels, Virtual Box, etc) may work but is not supported. If wish to use VCDS on a computer with this 'Student' version of Windows, you'll need to upgrade it to Windows 10 Pro. VCDS does not work on 'Windows 10 S', which does not allow software to be installed from any source other than the Microsoft Store. Release 18.9 works with Windows 7, 8, and 10 (both 32-bit and 64-bit)Įarlier versions of Windows such as 2000, XP, and Vista might still work, but we no longer consider them supported. Support Vehicle: For AUDI,VW, SKODA, Seat Support Language: Chinese, English, French, German, Russian, Italian, Swedish, Danish, Czech, polish, Dutch, Hungarian, Portuguese, Spanish, Slovenia, Romania. Update: Software Update Online,Hardware update automatic when work with newer version software !ZaRwnC6J!0V7vDSs5hBIi-pmr1-uUz2D-4FxxLfJuimzyLu18V6o VAG COM VCDS 18.9.1 New V18.9.1 VAG Com Cable work With VCDS Loader V1.12ĭownload vcds 18.9.1 from offical website: Ross Tech VCDS 18.9.1 Crack Cable Genuine VCDS 18.91 Diagnostic Interface With VCDS 18.9.1 Download Software VAG COM VCDS 18.9.1 is New V18.9.1 VAG Com Cable For VAG Car Audi VW Diagnose. VCDS 18.91 Diagnostic Interface With VCDS 18.9.1 Download Software. VCDS Version: 18.9.1.0 HEX-V2 CB: 0.4436.Ross Tech VCDS 18.9.1 Crack Cable VAG COM Can work With VCDS Loader V1.12. P012C - Turbocharger/Supercharger Inlet Pressure Sensor: Short to Ground P012B - Turbocharger/Supercharger Inlet Pressure Sensor: Implausible Signal VCDS Version: 18.9.1.0 HEX-V2 CB: 0.4436.4ĦF:Turbo Inlet Press A/B TCA_PRESS: 58 kPa absħ0:Boost Press Ctrl A/B BP_A act:29 kPa BP_B act:29 kPaĠE:Ignition timing advance for cyl #1 21.0 Degrees VCDS - Windows Based VAG/VAS Emulator Running on Windows 7 x86 I'm trying to get the car sorted before I start throwing a tune on it. If I try to push the gas pedal during the rpm increase there is no response.

At times when sitting in a parking lot running the RPM's will creep up to 1400 all by itself, then drop down immediately and stall. car also has b1 S1 B2 S1 o2 codes as well but it looks like they only faulted once. but they looked like they were working correctly. I tried to log the map sensors not sure if I did it right. I didn't have vcds before, I'm still fairly new at using it now that i have it. It helped for a short while but now i'm getting the same codes again.

I replaced the pre inlet map sensor a few months ago. So my s4 has been acting up for a while now.

Vcds 18.9 short to ground